The digi test II consist of 4 major components: the test stand, the loading module (pick-up bracket), the electronic unit and the interchangeable measuing unit for methods of Shore, IRHD and VLRH.
The highly intelligent digi test II is equiped with an electronic unit which serves as the main control of the entire system and the display of the user's information for measuring time and method, measurement and various selectable features.
Unlike the conventional hardness testers which are limited to only flat-surfaced samples measuring, the Bareiss digi test II is making hardness testing on all surfaces possible by using the automatic surface detection technology.
In addition to that, we are able to customize our indenter length so that it can reach any point on the sample which is required for measuring.
Bareiss offers a wide range of standard sample holders but we are also specialized in customized holders for your particular products. Please contact the sales team for your individual solution.
You will find some of the standard positioning devices for O-Rings and tubes further down this page.
The easy plug-and-play solution requires no complicated setup. The measuing unit can be securely installed simply by hand fastening a knurl nut and once done, the electronic unit automatically detects the type of the installed measuing method and time acc. to standards.
for soft rubber, highly elastic materials and plastically deformable materials of a material thickness from 6 up to 10 mm
from 10 up to 12 mm Hysteresis function
for sponge and cellular rubber, foam rubber, silicone, similar to gel materials from a material thickness of 6 mm
for sponge and cellular rubber, foam rubber, silicone, similar to gel materials from a material thickness of 1 mm
for concave and convex moulded parts of a material thickness of 4 or 6 mm
from a minimum thickness of 1 mm
for moulded parts of a material thickness of 4 or 6 mm
from a minimum thickness of 1 mm
Centering device for a quick centring of O-rings of a cord diameter between 0,6 to 5,0 mm.
Outer diameter up to 50 mm
Centering device for O-Rings with a cord diameter from 0.6 to 8.0 mm and max. outer diameter of 200 mm.
With plexiglas plate (200 x 200 mm) and a sample clamping device. Plexiglas plates with different sizes are available.
Automatic centering device for quick centering of O-rings in order to minimize operators influence.
Compatible with digi test II only
Centering device allows to measure on every point of the oil seal.
Standard rubber blocks are used to ensure the metrological capability of the measuring device acc. to IRHD during the frequency of recalibration. The rubber blocks are embedded in a holder made of stainless steel.
Applicable for all electronic Bareiss testing devices with a serial interface. The programme contains all functions which are necessary for a faultless process
When a measuring instrument is being calibrated, the given deviation is determined by various measurements versus standard references. A calibration certificate is then issued indicating the measuring results and the corresponding measurement uncertainties and the instrument is marked as calibrated.
All documents together with the calibration certificate provide traceability of national standards.